Dell PowerEdge M IO Aggregator Command Reference Manual page 91

Figure 6-15. show interface dcbx detail Command Example
FTOS# show interface tengigabitethernet 0/49 dcbx detail
FTOS# show interface te 0/49 dcbx detail
E-ETS Configuration TLV enabled
R-ETS Recommendation TLV enabled
P-PFC Configuration TLV enabled
F-Application priority for FCOE enabled
I-Application priority for iSCSI enabled
------------------------------------------------------------------------------------------
Interface TenGigabitEthernet 0/49
Remote Mac Address 00:00:00:00:00:11
Port Role is Auto-Upstream
DCBX Operational Status is Enabled
Is Configuration Source? TRUE
Local DCBX Compatibility mode is CEE
Local DCBX Configured mode is CEE
Peer Operating version is CEE
Local DCBX TLVs Transmitted: ErPfi
Local DCBX Status
-----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 0
Sequence Number: 2
Acknowledgment Number: 2
Protocol State: In-Sync
Peer DCBX Status:
----------------
DCBX Operational Version is 0
DCBX Max Version Supported is 255
Sequence Number: 2
Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
Table 6-5. show interface dcbx detail Command Description
Field
Interface
Port-Role
DCBX Operational Status
Configuration Source
Local DCBX Compatibility
mode
e-ETS Configuration TLV disabled
r-ETS Recommendation TLV disabled
p-PFC Configuration TLV disabled
f-Application Priority for FCOE disabled
i-Application Priority for iSCSI disabled
Interface type with chassis slot and port number.
Configured DCBX port role: auto-upstream or auto-downstream.
Operational status (enabled or disabled) used to elect a configuration source
and internally propagate a DCB configuration. The DCBX operational status
is the combination of PFC and ETS operational status.
Specifies whether the port serves as the DCBX configuration source on the
switch: true (yes) or false (no).
DCBX version accepted in a DCB configuration as compatible. In
auto-detection mode, a port can only operate on a DCBX version supported on
the remote peer.
Description
Data Center Bridging (DCB) | 77