Adding A Stack Unit - Dell PowerEdge M IO Aggregator Command Reference Manual

Note: If the stacked switches all reboot at approximately the same time, the switch with the highest MAC address is
automatically elected as the master switch. The switch with the next highest MAC address is elected as standby. As
each switch joins the stack, it is assigned the lowest available stack-unit number from 0 to 5. The default
configuration of each stacked switch is stored in the running configuration of the stack. The stack-unit ID numbers
are retained after future stack reloads.
To verify the stack-unit number assigned to each switch in the stack, use the
(Figure 17-18).

Adding a Stack Unit

You can add a new unit to an existing stack both when the unit has no stacking ports (stack groups)
configured and when the unit already has stacking ports configured. If the units to be added to the stack
have been previously used, they are assigned the smallest available unit ID in the stack.
To add a standalone Aggregator to a stack, follow these steps:
Step Task
1 Power on the switch.
2 Attach QSFP or direct attach cables to connect 40GbE ports on the switch to one or more switches in the stack.
3 Log on to the CLI and enter global configuration mode.
4 Configure the Aggregator to operate in stacking mode.
5 Reload the switch. FTOS automatically assigns a number to the
new unit and adds it as member switch in the stack. The new
unit synchronizes its running and startup configurations with the
stack.
If an Aggregator is already configured to operate in stacking mode, simply attach QSFP or direct attach
cables to connect 40GbE ports on the base module of each stacked Aggregator. The new unit synchronizes
its running and startup configurations with the stack.
FTOS Behavior: When you add a new
• If the new unit has been configured with a stack number that is already assigned to a stack mem-
ber, the stack avoids a numbering conflict by assigning the new switch the first available stack
number.
• If the stack has been provisioned for the stack number that is assigned to the new unit, the
pre-configured provisioning must match the switch type. If there is a conflict between the provi-
sioned switch type and the new unit, a mismatch error message is displayed.
210 | Stacking
Command Syntax
Login: username
Password: *****
FTOS> enable
FTOS# configure
stack-unit 0 iom-mode
stack
reload
Aggregator
to a stack:
command
show system brief
Command Mode
---
CONFIGURATION
EXEC Privilege