Stack Unit In Card-Problem State Due To Incorrect Ftos Version; Stack Unit In Card-Problem State Due To Configuration Mismatch - Dell PowerEdge M IO Aggregator Command Reference Manual

Mxl 10/40gbe switch io module ftos command reference guide, ftos 8.3.16.1
Hide thumbs Also See for PowerEdge M IO Aggregator:
Table of Contents

Advertisement

Stack Unit in Card-Problem State Due to Incorrect FTOS Version

Problem: A stack unit enters a Card-Problem state because the switch has a different FTOS version than
the master unit
(Figure
17-29). The switch does not come online as a stack unit.
Resolution: To restore a stack unit with an incorrect FTOS version as a member unit, disconnect the
stacking cables on the switch and install the correct FTOS version. Then add the switch to the stack as
described in
Adding a Stack
back online, use the
show system brief
Figure 17-29. Card Problem Error - Different FTOS Versions
FTOS#show system brief
Stack MAC : 00:1e:c9:f1:00:9b
--
Stack Info
--
Unit
UnitType
Status
------------------------------------------------------------------------------------
0
Management
online
1
Standby
card problem
2
Member
not present
3
Member
not present
4
Member
not present
5
Member
not present
Figure 17-30. Card Problem Error - Different FTOS Versions: Resolved
FTOS#show system brief
Stack MAC : 00:1e:c9:f1:04:82
--
Stack Info
--
Unit
UnitType
Status
------------------------------------------------------------------------------------
0
Management
online
1
Standby
online
2
Member
not present
3
Member
not present
4
Member
not present
5
Member
not present

Stack Unit in Card-Problem State Due to Configuration Mismatch

Problem: A stack unit enters a card-problem state because there is a configuration mismatch between the
logical provisioning stored for the stack-unit number on the master switch and the newly added unit with
the same number.
Resolution: From the master switch, reload the stack by entering the
mode. When the stack comes up, the card problem will be resolved
Unit. To verify that the problem has been resolved and the stacked switch is
command
(Figure
ReqTyp
I/O-Aggregator
I/O-Aggregator
ReqTyp
I/O-Aggregator
I/O-Aggregator
17-30).
CurTyp
Version
I/O-Aggregator
8-3-17-46
unknown
CurTyp
Version
I/O-Aggregator
8-3-17-52
I/O-Aggregator
8-3-17-52
command in EXEC Privilege
reload
Ports
56
56
Ports
56
56
Stacking | 219

Advertisement

Table of Contents
loading

Table of Contents