Dell PowerEdge M IO Aggregator Command Reference Manual page 152

Command Syntax
monitor interface
The information displays in a continuous run, refreshes every two seconds by default
the following keys to manage the output.
m - Change mode
T - Increase refresh interval (by 1 second)
q - Quit
Figure 10-18.
FTOS#monitor interface tengig 3/1
Dell Force10 uptime is 1 day(s), 4 hour(s), 31 minute(s)
Monitor time: 00:00:00
Interface: TenGig 3/1, Disabled, Link is Down, Linespeed is 1000 Mbit
Traffic statistics:
Input bytes:
Output bytes:
Input packets:
Output packets:
64B packets:
Over 64B packets:
Over 127B packets:
Over 255B packets:
Over 511B packets:
Over 1023B packets:
Error statistics:
Input underruns:
Input giants:
Input throttles:
Input IP checksum:
Input overrun:
Output underruns:
Output throttles:
m - Change mode
l - Page up
T - Increase refresh interval
q - Quit
138 | Interfaces
Command Mode
interface EXEC Privilege
l - Page up
Command Example
monitor interface
Refresh Intvl.: 2s
Input CRC:
Purpose
View interface statistics. Enter the type of interface and slot/
port information:
• For a 1GbE interface, enter the keyword
followed by the slot/port numbers; for example, interface
tengigabitethernet 0/12.
• For a 10GbE interface, enter the keyword
TenGigabitEthernet
for example, interface tengigabitethernet 0/44.
c - Clear screen
a - Page down
t - Decrease refresh interval (by 1 second)
Current Rate
0 0 Bps
0 0 Bps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
0 0 pps
c - Clear screen
a - Page down
t - Decrease refresh interval
GigabitEthernet
followed by the slot/port numbers;
(Figure 10-18). Use
Delta
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0