Fetching Dynamic Mac Entries Using Snmp - Dell PowerEdge M IO Aggregator Command Reference Manual

Figure 16-6 shows the output for an Aggregator. All hex pairs are 00, indicating that no ports are assigned
to VLAN 10. In
from 00 to 04.
Figure 16-7. Displaying Ports in a VLAN using SNMP
[Dell Force10 system output]
FTOS(conf)#do show vlan id 10
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status
10 Inactive
[Unix system output]
> snmpget -v2c -c mycommunity 10.11.131.185 .1.3.6.1.2.1.17.7.1.4.3.1.2.1107787786
SNMPv2-SMI::mib-2.17.7.1.4.3.1.2.1107787786 = Hex-STRING: 40 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00
The value 40 is in the first set of 7 hex pairs, indicating that these ports are in Stack Unit 0. The hex value
40 is 0100 0000 in binary. As described above, the left-most position in the string represents Port 1. The
next position from the left represents Port 2 and has a value of 1, indicating that Port 0/2 is in VLAN 10.
The remaining positions are 0, so those ports are not in the VLAN.
Note that the table contains none of the other information provided by the
speed or whether the ports are tagged or untagged.

Fetching Dynamic MAC Entries Using SNMP

The Aggregator supports the RFC 1493 dot1d table for the default VLAN and the dot1q table for all other
VLANs.
Note: The 802.1q Q-BRIDGE MIB defines VLANs with regard to 802.1d, as 802.1d itself does not define
them. As a switchport must belong to a VLAN (the default VLAN or a configured VLAN), all MAC address
learned on a switchport are associated with a VLAN. For this reason, the Q-Bridge MIB is used for MAC
address query. Moreover, specific to MAC address query, dot1dTpFdbTable is indexed by MAC address
only for a single forwarding database, while dot1qTpFdbTable has two indices —VLAN ID and MAC
address —to allow for multiple forwarding databases and considering that the same MAC address is
learned on multiple VLANs. The VLAN ID is added as the first index so that MAC addresses can be read
by VLAN, sorted lexicographically. The MAC address is part of the OID instance, so in this case,
lexicographic order is according to the most significant octet.
Figure 16-7, Port 0/2 is added to VLAN 10 as untagged. And the first hex pair changes
Description Q Ports
U Tengig 0/2
command, such as port
show vlan
Simple Network Management Protocol (SNMP) | 195