Displaying Non-Default Configurations; Viewing Interface Information - Dell PowerEdge M IO Aggregator Command Reference Manual

Figure 10-21 shows the auto-negotiation options.
Figure 10-21. Setting Auto-Negotiation Options
FTOS(conf)# int tengig 0/0
FTOS(conf-if)#neg auto
FTOS(conf-if-autoneg)# ?
end
exit
mode
no
show
FTOS(conf-if-autoneg)#mode ?
forced-master
forced-slave
FTOS(conf-if-autoneg)#

Viewing Interface Information

Displaying Non-Default Configurations

The
show [ip | running-config] interfaces configured
have non-default configurations are displayed.
Figure 10-22 shows the possible
Figure 10-22. show Commands with configured Keyword Examples
FTOS#show interfaces configured
FTOS#show interfaces tengigabitEthernet 0 configured
FTOS#show ip interface configured
FTOS#show ip interface tengigabitEthernet 1 configured
FTOS#show ip interface brief configured
FTOS#show running-config interfaces configured
FTOS#show running-config interface tengigabitEthernet 1 configured
Exit from configuration mode
Exit from autoneg configuration mode
Specify autoneg mode
Negate a command or set its defaults
Show autoneg configuration information
Force port to master mode
Force port to slave mode
commands that have the
show
command allows you to display only interfaces that
keyword available.
configured
Interfaces | 145