Do Command; Undoing Commands - Dell PowerEdge M IO Aggregator Command Reference Manual

Figure 3-3
configuration mode.
Figure 3-3. Changing CLI Modes
FTOS(conf)# interface tengigabitethernet 1/2
FTOS(conf-if-te-1/2)#

do Command

Enter an EXEC mode or EXEC privilege mode command from any CONFIGURATION mode (such as
CONFIGURATION, INTERFACE, etc.) without returning to EXEC mode by preceding the EXEC mode
command with the command
Note: The following commands cannot be modified by the
Figure 3-4. Using the
FTOS(conf)#do show system brief
Stack MAC : 00:01:e8:00:ab:03
-- Stack Info
Unit UnitType
------------------------------------------------------------------------------------
0 Member
1 Management
2 Member
3 Member
4 Member
5 Member
FTOS(conf)#

Undoing Commands

When you enter a command, the command line is added to the running configuration file. Disable a
command and remove it from the running-config by entering the original command preceded by the
command
ip-address
Note: Use the
command.
12 | Configuration Fundamentals
shows how to change the command mode from CONFIGURATION mode to INTERFACE
. Figure 3-4
do
Command
do
--
Status
not present
online
not present
not present
not present
not present
. For example, to delete an ip address configured on an interface, use the
no
command, as shown in Figure
or command as described in
help ?
New command prompt
illustrates the
do
"do" form of show command
ReqTyp CurTyp
I/O-Aggregator I/O-Aggregator
3-5.
Obtaining Help
command.
command:
do enable, disable, exit
Version
8-3-17-38
to help you construct the
, and .
configure
Ports
56
no ip-address
form of a
no