Configure A Host Name; Access The System Remotely - Dell PowerEdge M IO Aggregator Command Reference Manual

Figure 4-7. Completed Boot Process (Contd.)
00:01:11: %STKUNIT0-M:CP %IFMGR-5-ASTATE_UP: Changed interface Admin state to up: Te 0/54
00:01:11: %STKUNIT0-M:CP %DIFFSERV-4-DSM_DCBX_ETS_RECO_TX_OVERRIDE: Port Role Change overrides the
configuration of ETS Recommend TLV transmitstatus: Te 0/54
00:01:11: %STKUNIT0-M:CP %IFMGR-5-ASTATE_UP: Changed interface Admin state to up: Te 0/54
00:01:11: %STKUNIT0-M:CP %DIFFSERV-4-DSM_DCBX_ETS_RECO_TX_OVERRIDE: Port Role Change overrides the
configuration of ETS Recommend TLV transmitstatus: Te 0/54

Configure a Host Name

The host name appears in the prompt. The default host name is FTOS.
• Host names must start with a letter and end with a letter or digit.
• Characters within the string can be letters, digits, and hyphens.
To configure a host name, follow this steps:
Step Task
1 Create a new host name.
Figure 4-8
Figure 4-8. Configuring a Hostname
FTOS(conf)#hostname R1
R1(conf)#

Access the System Remotely

You can configure the system to access it remotely by Telnet. The Aggregator has a dedicated management
port and a management routing table that is separate from the IP routing table.
28 | Getting Started
shows the command.
hostname
Default Hostname
New Hostname
Command Syntax
hostname name
Command Mode
CONFIGURATION