Navigating CLI Modes
The FTOS prompt changes to indicate the CLI mode.
information about how to access and exit this CLI mode. You must move linearly through the command
modes, with the exception of the
command moves you up one command mode level.
exit
Note: Sub-CONFIGURATION modes all have the letters "conf" in the prompt with additional modifiers to
identify the mode and slot/port information. These are shown in
Table 3-1. FTOS Command Modes
CLI Command Mode
EXEC
EXEC Privilege
CONFIGURATION
Note: Access the following modes from CONFIGURATION mode:
10 Gigabit Ethernet
Interface
Interface Range
Management Ethernet
Interface
Monitor Session
IP COMMUNITY-LIST
CONSOLE
VIRTUAL TERMINAL
command, which takes you directly to EXEC Privilege mode and the
end
Prompt
FTOS>
FTOS#
FTOS(conf)#
#
FTOS(conf-if-te-0/1)
#
FTOS(conf-if-range)
#
FTOS(conf-if-ma-0/0)
FTOS(conf-mon-sess)
FTOS(conf-community-list)#
FTOS(conf-line-console)#
FTOS(conf-line-vty)#
Table 3-1
lists the CLI mode, its prompt, and
Table
3-1.
Access Command
Access the router through the console or Telnet.
•
From EXEC mode, enter the command
•
From any other mode, enter the command
•
From EXEC privilege mode, enter the command
.
configure
•
From every mode except EXEC and EXEC
Privilege, enter the command
interface
interface
interface
monitor session
ip community-list
line
line
enable
.
end
exit
.
Configuration Fundamentals | 11
.