Step
Task (continued)
Note: Terminal settings on the console port cannot be changed in the software and are set as follows:
•
9600 baud rate
•
No parity
•
8 data bits
•
1 stop bit
•
No flow control
External Serial Port with a USB Connector
Table 4-1
lists the pin assignments.
Table 4-1. Pin Assignments
USB Pin Number
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5, 6
RxD
Boot Process
After you follow the instructions in the Installation Procedure in the Getting Started Guide, the Aggregator
boots up. The Aggregator with FTOS version 8.3.17.0 requires boot flash version 4.0.1.0 and boot selector
version 4.0.0.0.
Figure 4-3
through
Figure 4-7
Signal Name
RTS
RX
TX
CTS
GND
Chassis GND
show the completed boot process.
Getting Started | 23