Dell PowerEdge M IO Aggregator Command Reference Manual page 252

Figure 20-4.
FTOS#show interfaces tengigabitethernet 0/5
TenGigabitEthernet 0/5 is up, line protocol is down(error-disabled[UFD])
Hardware is DellForce10Eth, address is 00:1e:c9:f1:04:80
Current address is 00:1e:c9:f1:04:80
Server Port AdminState is N/A
Pluggable media not present
Interface index is 35197697
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :tenG134001ec9f10480
MTU 12000 bytes, IP MTU 11982 bytes
LineSpeed auto
Flowcontrol rx on tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:28:09
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
Time since last interface status change: 00:25:03
Figure 20-5.
FTOS# show running-config uplink-state-group
!
uplink-state-group 1
downstream TenGigabitEthernet 0/1-32
downstream TenGigabitEthernet 1/1-32
upstream Port-channel 128
defer-timer 10
238 | Uplink Failure Detection (UFD)
Command Output
show interfaces
show running-config uplink-state-group
0 packets/sec, 0.00% of line-rate
0 packets/sec, 0.00% of line-rate
Command: UFD Output