Table of Contents
Advertisement
Initial resolution setting
This setting is used to change the default
resolution setting for fax mode from "STANDARD"
to "FINE", "SUPER FINE", or "ULTRA FINE".
"HALF TONE" can also be selected for the latter
three resolution settings. "STANDARD" is normally
selected for the initial resolution setting. If you wish
to select "HALF TONE" for the selected resolution
setting, touch the [HALF TONE] key to highlight it.
NOTES
G "HALF
TONE"
cannot
"STANDARD" resolution.
G For more information on each of the resolution
settings, refer to page 1-9.
Own number and name set
Use this setting to enter the fax number of the
machine and the name of the user. The entered
name and number are printed at the top of each fax
page you send. The number is also used as a
passcode when performing polling reception (see
"USING THE POLLING FUNCTION" on page 3-6).
You can check your entries by printing out the
Sender List. Refer to page 8-12.
1
Touch the [NAME] key and enter the name.
The name entry screen appears.
Up to 20 characters can be entered for the name.
Refer to page 6-15 for the procedure for entering
characters.
2
Touch the [FAX No.] key and enter the fax
number.
Enter up to 20 digits for the number using the
numeric keys.
To enter a "+", press the "
To enter a hyphen, touch the [PAUSE] key. To
enter a space, touch the [SPACE] key.
If you make a mistake, press the [C] key and
re-enter the correct digit.
NOTE
If a hyphen is entered, it will be changed to a space
at the time of transmission.
3
Touch the [OK] key.
You will return to the OWN NUMBER AND NAME
SET screen. The number you entered appears.
Make sure it is correct.
be
selected
for
" key.
KEY OPERATOR PROGRAMS
Auto wake up print
Use this setting to select how the machine
responds if a fax is received when the main switch
is turned off (the fax power switch is turned on).
Auto wake up print is normally turned on, which
means that the machine automatically activates
and prints the received fax. If you turn off this
setting, received faxes will not be printed until the
main switch is turned on.
Pause time setting
This setting is used to select the duration of pauses
that are inserted in destination fax numbers.
Normally the setting is 2 seconds, which means
that each time the [PAUSE] key is touched when
dialing or storing a fax number, a pause of 2
seconds is inserted.
The pause time can be set to any number of
seconds from 1 to 15.
Original print on transaction report
This program is used to have part of the first page
of the fax printed on the transaction report . This
program is used in conjunction with the transaction
report print select setting (next page), and is not
effective when printing of the transaction report is
disabled.
This program is normally configured so that part of
the fax is printed on the transaction report when a
transmission is not successful.
Speaker volume setting
This program is used to adjust the volume of the six
following sounds that are emitted from the speaker:
1.speaker, 2. ringer volume, 3. line monitor, 4. fax
receive signal, 5. Fax communication error signal,
6. scan complete sound.
KEY OPERATOR PROGRAMS
VOLUME ADJUSTMENT
SPEAKER
RINGER VOLUME
LINE MONITOR
Volume:Low Volume:Medium
To change the volume, touch the desired volume
key.
Factory
default
destinations.
OK
Volume:High
Off
setting
varies
with
8-5
8
Advertisement
Chapters
Table of Contents
