Own Number Sending - Sharp AR-FX10 Operation Manual

OWN NUMBER SENDING

This function prints the date, time, your programmed name, your programmed fax number, and the transmitted page
number at the top centre of each page that you fax. All pages that you fax include this information.
Example of fax page printed out by the receiving machine
11/JUN/2004/FRI 15:00
(1)
(1) Date and time: programmed in the custom settings (page 2-13 of "Operation manual (for general information
and copier operation)").
(2) Own name: programmed with the key operator program. (See "Own number and name set" on page 8-5.)
(3) Own fax number: programmed with the key operator program (See "Own number and name set" on page
8-5.).
(4) Transmitted page number: 3-digit number appearing in the format, "page number/total pages" (only the page
number appears if you use manual transmission or Quick On-Line transmission). If desired, you can use the
key operator program to omit the page number. (See "Printing page number at receiver" on page 8-7.)
I I I I Position of sender's information
The key operator program can be used to select whether the sender's information is added outside the original
data or inside the data. (See "Date/own number print position setting" on page 8-8). The initial factory setting is
outside the data.
Direction of transmission
Outside scanned data
SHARP PLANNING DIV.
(2)
None of the transmitted
image is cut off; however,
the transmitted data is
longer than the scanned
data, and thus when both
the sender and the receiver
use the same size of paper,
the printed fax may either
be reduced or split up and
printed on two pages.
FAX No. 0666211221
(3)
Direction of transmission
Inside scanned data
P. 001/001
(4)
The top edge of the
scanned data will be cut off
by the sender's
information; however,
when both the sender and
the receiver use the same
size of paper, the printed
fax will neither be reduced
nor split up and printed on
two pages.
3-9
3