Default Exposure Settings; Distinctive Ring Detection; Auto Reduction Sending Setting; Disable Of Fax Number Direct Entry - Sharp AR-FX10 Operation Manual

Default exposure settings

This program is used to set the default exposure
level for scanning originals in fax / image send
mode.
This program is initially set to "AUTO". If changed
to "MANUAL", the exposure level can be adjusted
to five levels. Level 1 is the lightest level and level
5 is the darkest level.

Distinctive ring detection

This program can only be activated in Australia,
and New Zealand.
If multiple telephone numbers have been assigned
to your telephone line, the number called can be
identified by its ringing pattern. By using one
number for voice calls and another number for
faxes, you can tell which type of call you are
receiving by the ringing pattern. You can set your
machine to automatically receive faxes when your
fax number is called by setting the pattern that
corresponds to your fax number. Normally OFF is
selected.

Disable of fax number direct entry

When the fax function is enabled, this program is
used to prohibit dialing of a destination fax number
by direct entry with the numeric keys. To prohibit
dialing by direct entry with the numeric keys, touch
the checkbox to select it. When this is done, faxes
can only be sent to destinations that have been
stored, and thus this program can be used to
restrict fax destinations and prevent accidental
transmission to an incorrect number. The following
operations are also prohibited:
G Storing, amending or deleting one-touch dial
numbers
G Storing, amending or deleting a group
KEY OPERATOR PROGRAMS
I I I I Fax send settings
The fax send settings can be used to enable or
disable fax transmission functions as needed for your
workplace.
The "Fax send settings" are as follows:
G Auto reduction sending setting
G Rotation sending setting
G Printing page number at receiver
G Call timer at memory sending
G Date/own number print position setting
G Quick on line sending
G Recall in case of line busy
G Recall in case of communication error

Auto reduction sending setting

This setting lets you select whether to have a
transmitted document reduced to match the size of
the other machine's printing paper. Auto reduction
is normally turned on. If the setting is turned off,
documents are sent in their original size. Because
the size is not adjusted to match the size of the
printing paper, part of the received document may
be cut off.

Rotation sending setting

When transmitting a document, this setting allows
you to rotate a vertically oriented A4 (8-1/2"x11")
document to a horizontal orientation (A4R
(8-1/2"x11"R )), rotate a B5R document to B5, or
rotate a A5R (5-1/2"x8-1/2R") document to A5
(5-1/2"x8-1/2"). The setting is normally turned on,
and documents are rotated clockwise. (A4R
(8-1/2"x11"R) documents are not rotated.)
KEY OPERATOR PROGRAMS
ROTATION SENDING SETTING
ORIGINAL
Rotation settings can be separately established for
different document sizes. To turn off a rotation
setting, touch the checkbox of the appropriate
setting to remove the checkmark.

Printing page number at receiver

This setting lets you select whether page numbers
are printed at the top of fax pages by the receiving
machine. The normal setting is to have page
numbers printed.
OK
SENDING
DIRECTION
8-7
8