Sharp AR-FX10 Operation Manual page 75

Problem
Printing does not take Does a message appear in the
place after reception. display instructing you to add
toner or paper? (Printing is not
possible.)
A received image Was the wrong side of the
prints out blank. original
transmitting machine?
The received image is Is the original faint?
faint.
The received image is Were line conditions poor due to
distorted. thunder or another reason?
White or black lines Is the document glass dirty?
appear in the
transmitted image.
A dial tone is not Is the volume set to "low"?
heard through the
speaker.
A ringing sound is Has the ringer volume been
not made. turned off?
Check
Restore printing capability
as instructed by the display
message.
begin.
Check with the operator of
scanned in the the transmitting machine.
Ask the other party to re-
send the document using a
suitable exposure setting.
Ask the other party to send
the document again.
Clean the document glass . Operation
Set the speaker volume to
"medium" or "high".
Set the ringer volume to
"low", "medium", or "high".
PROBLEMS AND SOLUTIONS
Solution
"WHEN AN ALARM SOUNDS
AND A WARNING MESSAGE
Printing will IS DISPLAYED", page 7-3.
general
copier operation), page 7-3.
"Speaker volume setting",
page 8-5.
"Speaker volume setting",
page 8-5.
Page
_
_
_
manual (for
information and
7
7-5