A Look At The Operation Panel - Sharp AR-FX10 Operation Manual

A LOOK AT THE OPERATION PANEL

The operation panel used for the fax function is described below.
Touch panel (following page)
1
• Messages and keys appear on the touch panel.
Key input is accomplished by touching the keys.
• When a key in the touch panel is touched, a beep
sounds and the key is highlighted.
• Keys that cannot be selected in a screen are
greyed out. If touched, a double-beep will sound
to alert you that the key cannot be selected.
Mode select keys (page 2-2)
2
Use these keys to change modes.
[IMAGE SEND] key
3
Press to switch to fax mode. The initial screen of
fax mode will appear.
When the network scanner option is installed,
touch this key to return to the initial screen of fax
mode or scanner mode, whichever mode was
selected last. (Pressing the [IMAGE SEND] key in
a copy screen or printer screen returns you to the
initial screen of fax mode.) To switch to the initial
screen of fax mode from the initial screen of
scanner mode, touch the [SCANNER/FAX] key
(see on page 1-4).
8
Numeric keys
4
Use to enter fax numbers, sub-addresses,
passcodes, and numerical
"MEMORY
SUB-ADDRESSES/PASSCODES
FOR F-CODE TRANSMISSION" on page 4-2.)
On the model for Singapore, alphabets are
described on each numeric key.
NOTE
For the names and functions of the parts of the machine, see page 1-4 of the "Operation manual (for general
information and copier operation)".
1
settings. (See
BOXES AND
REQUIRED
2 3 4
7
[C] key (clear key)
5
Use to clear a mistake when entering fax numbers,
sub-addresses,
settings. One digit is cleared each time you press
the key.
When an original is being scanned, this key can
also be used to cancel scanning.
[CA] key (clear all key)
6
Use to cancel a transmission or programming
operation. When this key is pressed, the operation
is cancelled and you return to the initial screen
described on the following page.
This key is also used to cancel a resolution, paper
size, or special function setting that was selected
when sending a fax.
[ ] key (page 5-4)
7
This is used to produce tone signals when you are
on a pulse dial line.
[BLACK COPY START] key (page 2-3)
8
Press to begin scanning an original for fax
transmission.
[COLOUR COPY START] key
9
Not used when using the machine as a fax
machine. (For information on this key, see page
1-8 of the "Operation manual (for general
information and copier operation)".)
5 6 9
8
passcodes, and numerical
1-3
1