Removing Printer Mechanism/Housing, Lower - Epson Stylus Photo R310 Service Manual

Stylus Photo R300/R310
2.3.15 Removing Printer Mechanism/
Housing, Lower
External View
C.B.S 3x6 (5-7kgf•cm)
1 2 3
C.B.P 3x8 (5-7kgf•cm) Paper Guide, CDR
4
Screw, Frame, Main (6-8kgf•cm)
Combination Lever, Change
Gear, 27.2, 19.2
Wire Band
Figure 2-38. Removing "Printer Mechanism"/"Housing, Lower" (1)
DISASSEMBLY AND ASSEMBLY
C.B.S 3x6 (6-8kgf•cm)
C.B.P 3x10 (6-8kgfcm)
1
2
C.B.P 3x10 (6-8kgf•cm)
3
5
Hook
(Under the tube)
Hooks
Figure 2-39. Removing "Printer Mechanism"/"Housing, Lower" (2)
Parts/Units which should be removed before removing "Printer
Mechanism"/"Housing, Lower"
Paper Support Assy./Housing, Upper/Housing, Middle/Main Board Unit/
ASF Assy./Holder, Shaft Assy.
Procedure for Removing
1. Move "Carriage Unit" to the centre of the printer.
2. Remove the screws (x3) which secure "Paper Guide, CDR".
3. Remove the screws (x5) which secure "Printer Mechanism".
4. Take off the acetate tape and release the connector of "Star Wheel/CDR
Sensor".
5. Cut off the wire band and release the connector cable.
6. Release the hooks (x4) which secure "Printer Mechanism". Then, hold the
both right and left upper edges of "Frame, Main" and remove "Printer
Mechanism" to upward.
Disassembly
Revision A
2 ± 1mm
Acetate Tape
Handling Position
Hook
64