Epson Stylus Photo R310 Service Manual page 77

Stylus Photo R300/R310
Reinstalling "Paper Guide, Front"
Make sure that the dowels and the hook of "Paper Guide,
Front" are correctly secured to "Frame, Main".
Hook
Figure 2-57. Reinstalling "Paper Guide, Front"
Make sure that the tabs of "Porous Pad, Paper Guide, Front,
Left" and "Porous Pad, Paper Guide, Front, Support" are
facing straight to downward through the slots of "Paper
Guide, Front".
Make sure that there is no gap between "Paper Guide,
Front" and "Frame, Main".
If any ink leaks on the rib of "Paper Guide, Front", clean it
with a cotton swab. (At this time, take care not to touch
"Porous Pad, Paper Guide, Front" of "Paper Guide, Front"
with the cotton swab.)
Reinstalling "Roller EJ Assy."
Make sure that both left and right "Bushing, 5" are
correctly secured.
Make sure that "Grounding Spring, EJ Left (Right)" is
correctly attached to the both ends of "Roller EJ Assy.".
When installing "PF Timing Belt", do not damage the teeth
of "Spur Gear, 41.48".
Make sure that "Roller EJ Assy." moves smoothly.
DISASSEMBLY AND ASSEMBLY
When replacing "Roller EJ Assy.", apply G-26 grease in the
adequate dose to the specified points.
When removing or replacing "PF Timing Belt", implement the
tension adjustment with the digital tension gauge.
When having removed or replaced "Paper Guide, Front",
implement the following adjustment. (Refer to Chapter 3
"ADJUSTMENT")
1.
2.
Dowels
3.
4.
Disassembly
First Dot Adjustment
PW Sensor Adjustment
Head Angular Adjustment
Bi-D Adjustment
Revision A
77