Removing Porous Pad, Paper Guide, Front - Epson Stylus Photo R310 Service Manual

Stylus Photo R300/R310

2.3.4 Removing Porous Pad, Paper Guide, Front

External View
Porous Pad, Paper Guide, Front, Left Porous Pad, Paper Guide, Front, Left
Porous Pad, Paper Guide, Front, Support
Figure 2-10. Removing "Porous Pad, Paper Guide, Front"
Pars/Units which should be removed before removing "Porous Pad, Paper
Guide, Front"
Paper Support Assy./Housing, Upper"/"Housing, Middle
Procedure for Removing
1. Remove the following 3 types of porous pads from "Paper Guide, Front"
using the tweezers.
• Porous Pad, Paper Guide, Front
• Porous Pad, Paper Guide, Front, Support
• Porous Pad, Paper Guide, Front, Left
Make sure to take "Porous Pad, Paper Guide, Front" cleanly as it
is glued.
DISASSEMBLY AND ASSEMBLY
Porous Pad, Paper Guide, Front
Folding Points
Disassembly
Vertical Direction: 4 ± 1mm
Horizontal Direction: 1-2mm
Vertical Direction: 4 ± 1mm
Horizontal Direction: 2-3mm
Figure 2-11. Gluing Point of "Porous Pad, Paper Guide, Front"
Reinstalling "Porous Pad, Paper Guide, Front"/"Porous Pad,
Paper Guide, Front, Support"
Fold perpendicularly left and right sides of "Porous Pad,
Paper Guide, Front, Support" at the marks and install it to
"Paper Guide, Front". Make sure that the slit engages with
the rib located on the side of "Paper Guide, Front" so that
they will fit securely.
Apply ThreeBond 1401 to the 6 points shown in the figure
above.
Install "Porous Pad, Paper Guide, Front" in piles. Put it
under the rib, and check if it is securely fit. Adjust the
clearance between "Porous Pad, Paper Guide, Front" and
"Paper Guide, Front" approximately in 0.5 - 1.0mm.
Reinstalling "Porous Pad, Paper Guide, Front, Support"
Insert the foot-parts into the holes of "Paper Guide, Front".
Then, put them under the rib and check if it is securely fit.
Do not damage "Porous Pad, Paper Guide, Front, Support".
Do not apply too much adhesive when using some. Do not
contaminate "Porous Pad, Paper Guide, Front, Support" with
the adhesive.
Install "Porous Pad, Paper Guide, Front" immediately after
applying the adhesive.
Make sure that the 3 porous pads are fit securely.
Revision A
Horizontal Direction
: 3-4mm
Horizontal Direction
: 5-6mm
43