Lower Housing / Printer Mechanism - Epson Stylus Office T1110 Service Manual

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100

4.4.4 Lower Housing / Printer Mechanism

1. Remove the Upper Housing / Printer Cover. (p.72)
2. Grip both ends of the Waste Ink Tube Fasteners with your fingers, slide them in
the direction of the arrows, and pull out the Waste Ink Tube from the Joint Tube.
3. Remove the C.B.P. M3 x 12 screw and the C.B.S. (P2) M3 x 10 screw that secure
the Shield Plate Holder, and remove the Shield Plate Holder.
4. Remove the five screws (four C.B.P. M3 x 10 screws and one C.B.S. (P2) M3 x 10
screw) secure the Printer Mechanism.
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
Disassembling the Printer Mechanism
1) C.B.P. M3x10
1
Printer Mechanism
2
1) C.B.P. M3x10
(6±1 kgf.cm)
Left Rear
3) C.B.S. (P2) M3x10
(6±1 kgf.cm)
5
Lower Housing
Figure 4-51. Screws that Secure the Printer Mechanism
打印机驱动下载 http://www.printerwhy.com/
Revision A
(6±1 kgf.cm)
Step 2
Joint Tube
Waste Ink Tube
Fastener
Right Rear Shield Plate Holder
3) C.B.S. (P2) M3x10
(6±1 kgf.cm)
A
Step 3
B
18) C.B.P. 3x12
(6±1 kgf.cm)
Confidential
4
3
86