Epson Stylus Photo R310 Service Manual page 61

Stylus Photo R300/R310
Reinstalling "CSIC Board"
Check if "CSIC Board" is secured correctly.
Reinstalling "PW Sensor Board"
Check if "PW Sensor FFC" is correctly connected.
Check if "PW Sensor Board" is correctly secured with
"Cap, PW Sensor".
Reinstalling "CR Encoder Sensor Board"
Check if "CR Encoder Sensor Board" is correctly secured.
Check if "CR Encoder Sensor Board" is correctly
connected.
Reinstalling "Holder, Scale, Right (Left)"
Check if "Slider, Holder, Scale" is set.
Figure 2-33. Reinstalling "Slider, Holder, Scale"
DISASSEMBLY AND ASSEMBLY
Slider, Holder, Scale
Reinstalling "Carriage Unit"
Check if "Timing Belt" is correctly set to the installing
groove of "Carriage Unit".
Check if "Grounding Plate, Head" is installed to the proper
position of "Carriage Unit".
Figure 2-34. Installing Position of "Grounding Plate, Head"
Reinstalling "CR Scale"
Make sure that "Extension Spring, 3.289" is not twisted.
Make sure to pass "CR Scale" through the slit of "CR
Encoder Sensor".
Make sure to install "CR Scale" the cut-part on the left edge
up.
Reinstalling "Guide, CR"
Screw in the order as shown in the figure.
Do not adhere the grease at the contact point of 'Carriage' and
"CR Lock Lever". Otherwise, fatal error may possible occur
because 'CR Lock Lever' is not moved.
Disassembly
Grounding Plate, Head
Cut-Part
Figure 2-35. Reinstalling "CR Scale"
Revision A
61