Epson Stylus Photo R310 Service Manual page 66

Stylus Photo R300/R310
Make sure that "Waste Ink Pads" (x6) are set correctly to
the rib and the dowel of "Housing, Lower".
Waste Ink Pad, Small
Cap, Ink Pad, Lower,
Small (Top)
Figure 2-42. Installing "Waste Ink Pads" (1)
DISASSEMBLY AND ASSEMBLY
Waste Ink Pad, Upper (Top)
Waste Ink Pad, Lower (Bottom)
Cap, Ink Pad, Lower,
Large (Bottom)
Disassembly
Figure 2-43. Installing "Waste Ink Pads" (2)
After checking "Waste Ink Tube" is under "Waste Ink Pad,
Lower", put the jig on the indicated points in the figure
below, then install "Porous Pad, Ink Eject, Upper, Support".
Porous Pad, Ink Eject,
Upper, Support
Jig
Figure 2-44. Installing "Porous Pad, Ink Eject, Upper, Support"
Revision A
Waste Ink Pad, Lower
Adjusting Point
66