Epson Stylus Photo R310 Service Manual page 70

Stylus Photo R300/R310
External View
Groove
Compression Spring, 5.1
Lock, Stacker
Shaft and Positioning Hole
Figure 2-49. Removing "CDR Guide Assy." (3)
8. Remove "Compression Spring, 5.1" and "Lock, Stacker" from "CDR Guide,
Upper".
DISASSEMBLY AND ASSEMBLY
Star Wheel/CDR Sensor
Hooks
9. Release the connector cable of "Star Wheel/CDR Sensor" from the groove of
"CDR Guide, Upper".
Reinstalling "Star Wheel/CDR Sensor"
Match the Shaft (x2) of "CDR Guide, Upper" and the
positioning hole of "Star Wheel/CDR Sensor".
Mount correctly the connector cable of "Star Wheel/CDR
Sensor" referring to the figure.
Reinstalling "CDR Guide, Upper"
Make sure that the hooks (x2) of "Lock Stacker" are
properly secured by the tension of "Compression Spring,
5.1".
Make sure that "CDR Guide, Upper" is securely secured
with the hooks (x7) of "CDR Guide, Lower" and there is no
gap between "CDR Guide, Upper" and "CDR Guide,
Lower".
Reinstalling "CDR Guide Assy."
Install "CDR Guide Assy." in the order of left edge, right
edge and middle.
Match the slot (x6) of "CDR Guide Assy." and the ribs (x6)
of "Frame, Main".
Check if "Link, CDR Left (Right)" is correctly installed.
Check if the connector cable of "Star Wheel/CDR Sensor" is
not interrupting "Link, CDR Right".
Check if "Frame, EJ Assy." works with "CDR Guide Assy."
and moves smoothly.
Disassembly
Revision A
70