Epson Stylus Photo R310 Service Manual page 59

Stylus Photo R300/R310
External View
Bushing, Parallel
C.P.S (P4) 3x6
Adjust, Right
(6-8kgf•cm)
CR Encoder CSIC Board
Sensor Board Connector
Hooks
Holder Pad, Ring
Oil Pad, Ring
Extension Spring, 26.46
Pulley, Driven
2
1
Figure 2-31. Removing "Carriage Unit" (3)
DISASSEMBLY AND ASSEMBLY
C.P.B (P1) 1.7x5
Holder, FFC ; B
(1.5-2.5kgf•cm)
Timing Belt
Hooks
CR Encoder Sensor Board PW Sensor FFC
C.P.B (P1) 1.7x5
Connector Slot
(1.5-2.5kgf•cm)
17. Remove the screw which secures "Bushing, Parallel Adjust, Left". Then,
remove "Bushing, Parallel Adjust, Left".
18. Remove "Timing Belt" from "Carriage Unit".
19. Remove the screws which secure "Holder, FFC; B". Then, remove "Holder,
FFC; B".
20. Remove "Cable, Head" from the connectors of "CSIC Board" and "CR
Encoder Sensor Board". Then, remove "Cable Head" from "Carriage Unit".
21. Release the hooks (x2) from "Holder Pad, Ring" (x2). Then, remove "Holder
Pad, Ring" (x2) and "Oil Pad, Ring" (x2).
Removing "Pulley, Driven"
1. Remove "Extension Spring, 26.46" from "Pulley Driven" and the hook of
"Frame, Main" by using a flat-blade screwdriver. Then, remove "Extension
Spring, 26.46".
2. Slide "Pulley, Driven" in the direction of the arrow. Then, remove "Frame,
Main" from the slot.
Removing "CR Encoder Sensor Board"
1. Remove the screw which secures "CR Encoder Sensor Board" with Phillips
screwdriver (No.0). Disconnect "PW Sensor FFC" from the connector of "CR
Encoder Sensor Board". Then, remove "CR Encoder Sensor Board".
Disassembly
Revision A
59