Epson Stylus Photo R310 Service Manual page 50

Stylus Photo R300/R310
When reassembling "ASF Assy."
Make sure that "Extension Spring, 0.45" is hooked on
"Frame, ASF" and "Roller, Retard Assy.".
Check if "Torsion Spring, 6.45" is correctly installed on
"Paper Back Lever" and "Frame, ASF".
Figure 2-19. Removing "Torsion Spring, 6.45"
Check if "Paper Back Lever" and "Roller, Retard Assy."
move smoothly.
Do not touch the cork of "Hopper".
Reinstalling "ASF Assy."
Install "Compression Spring, 2.51" on "Hopper", then
check if "Hopper" moves smoothly.
Screw in the order as shown in the figure.
Make sure that there is no gap between "ASF Assy." and
"Frame, Main".
DISASSEMBLY AND ASSEMBLY
Torsion Spring, 6.45
Disassembly
When having replaced "ASF Assy.", apply G-46 grease to the
specified points in adequate dose. (Refer to Chapter 4
"MAINTENANCE")
When having replaced or removed "ASF Assy.", implement the
adjustment in the following order. (Refer to Chapter 3
"ADJUSTMENT")
1. First Dot Adjustment
Revision A
50