Setting Date And Time - Kyocera TASKalfa 181 Operation Manual

Preparation before Use

Setting Date and Time

Follow the steps below to set the local date and time at the place of installation.
When you send an E-mail using the transmission function, the date and time as set here will be printed in the
header of the E-mail message. Set the date, time and time difference from GMT of the region where the machine
is used.
NOTE:
Be sure to set the time difference before setting the date and time.
System Menu / Counter:
Job Accounting
Copy Default
Machine Default
Enter Pin Code using # key.
Machine Default :
End
Auto Cassette SW
Paper Size(1st)
Machine Default :
Low Power Time
Key Sound On /Off
Date/Time:
Date/Time:
Time
DST
Time Zone
Date/Time:
End
Time
DST
2-8
:
On
: Auto I
: 1 Min.
: On
: 06:33
: 06:33
: On
: GMT + 00:00
:
06:33
: On
1
After turning on the main power switch, press the
System Menu/Counter key.
2
Press or repeatedly until Machine Default
appears, and press the Enter key.
3
Use the numeric keys to input the four-digit
management code. The management code at the
factory default setting is 1800 for the 18 ppm model
and 2200 for the 22 ppm model.
NOTE:
The four-digit management code can be
changed. For details, refer to Administrator
Management Code Change on page 6-24.
If the management code is accepted, the Machine
default screen is displayed.
NOTE:
The * (asterisk) at an item on each setting
screen indicates the current setting.
4
Press to select Date/Time, and then press
or
the Enter key.
5
Press to select Time Zone and then press
or
to set the time difference.
or
6
Press to select Time and then press
or
to set the current time.
or
OPERATION GUIDE