Kyocera TASKalfa 181 Operation Manual page 51

OPERATION GUIDE
3
Insert the paper along the paper width guides into
the tray until it stops.
IMPORTANT: Keep the side that was closest the
package seal facing up.
Put only the paper on the MP tray.
Do not load more paper than the paper feed capacity of
the MP tray.
Curled paper must be uncurled before use.
Straighten the top edge if it is curled.
When loading paper into the MP tray, check that there
is no paper left over in the tray from a previous job
before loading the paper. If there is just a small amount
of paper left over in the MP tray and you want to add
more, first remove the left-over paper from the tray and
include it with the new paper before loading the paper
back into the tray.
NOTE:
When loading paper into the MP tray, set it
with the side to be printed facing down.
Preparation before Use
2-19
2