Auto Continue - Kyocera TASKalfa 181 Operation Manual

Printing Functions

Auto Continue

If any of the following error messages appears, the error can be cleared and printing can be continued after the
preset recovery time elapses (auto continue).
• Memory Overflow/Press GO
• Print overrun Press GO
• KPDL error Press GO
• File not found Press GO
• HARD DISK error Press GO
• RAM disk error Press GO
• MemoryCard err Press GO
• Illegal Account Press GO
• Exceeded Max.out Press GO
• Account error Press GO
• Duplex disabled Press GO
• Add Staples and Press GO
• e-MPS not stored Press GO
• Opt. ROM error Press GO
Also you can set the time that elapses before auto continue is activated.
Others
Printer Reset
Resource Prot .
Auto Continue
Auto Continue
Back
On
Off
Auto Continue
On
Off
Change #
Auto Continue (Time)
30
5-48
sec. (0 495)
1
Display the Others screen. (See How to Display the
Others Screen on page 5-45.)
2
Press or to select Auto Continue, and then
press the Enter key.
3
Press or to select On or Off, and then press
the Enter key.
If you have selected On, Change # is displayed.
4
To set the time that elapses before auto continue is
activated, press
then press the Enter key.
The Auto Continue (time) screen is displayed.
5
Press or to enter the time, and then press the
Enter key.
You can set the time to 0 to 495 seconds in 5
second increments.
or to select Change #, and
OPERATION GUIDE