Set Ntp; Set Properties; Set Snmp - HP StorageWorks MPX200 User Manual

Set NTP

Configures the NTP parameters.
Authority
Syntax
Example:
MPX200 <1>(admin) #> set ntp
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
NTP (0=Enable, 1=Disable) [Disabled ] 0
TimeZone Offset from GMT (Min=-12:00,Max=12:00) [00:00 ] -8:0
IP Address [1] (IPv4 or IPv6) [0.0.0.0 ] 207.126.97.57
IP Address [2] (IPv4 or IPv6) [0.0.0.0 ]
IP Address [3] (IPv4 or IPv6) [0.0.0.0 ]
All attribute values that have been changed will now be saved.

Set properties

Configures blade CLI properties.
Authority
Syntax
Example:
MPX200 <1>(admin) #> set properties
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
CLI Inactivity Timer (0=Disable, 1=15min, 2=60min) [15min ]
CLI Prompt (Max=32 Characters) [HP StorageWorks MPX200 ]
All attribute values that have been changed will now be saved.

Set SNMP

Configures general SNMP) properties and eight trap destinations.
Authority
Syntax
Example 1: The following example shows the set snmp command for setting general properties:
188 Command referencecommand reference
Admin session
set ntp
Admin session
set properties
Admin session
set sn-
[trap_destinations]<DEST_NUM>]]
mp