Configuring an FCIP route and specifying an FC and GE port pair take precedence over any previous
configuration for the port pair (FC/GE). This means that for an existing or new iSCSI configuration,
once an FCIP Route is configured, one FC port and one GE port are no longer available for iSCSI or
DM use.
For existing iSCSI configurations, there are two configuration cases to consider: one with a single FC
fabric (see
Figure
79) connected to an MPX200 blade and one with dual FC fabrics (see
Figure
80)
connected to an MPX200 blade. In the single FC fabric case (see
Figure
79), the impact is minimal
and can be resolved by rezoning any targets that were zoned only with the FCIP FC port to the
remaining iSCSI FC port of that blade. Once the targets are rezoned, the impact to iSCSI is the loss
of one 1 GbE port.
Figure 79 FCIP impact on existing iSCSI configurations
single fabric per blade
.
MPX200 Multifunction Router User Guide
119