Adding Targets To The Qlogic Iscsi Initiator; Hba Port Target Configuration Window; Target Settings Tab - HP StorageWorks MPX200 User Manual

Adding targets to the QLogic iSCSI initiator

To add HBA port targets:
1. Click the green plus sign
2. Enter the first iSCSI target port IP address.
Figure 72 HBA Port Target Configuration window
.
3. Repeat steps 1 and 2 for each MPX200 you want to add.
4. Click Next.
5. To activate the changes, enter the SMS password: config.
6. Select the Target Settings tab. Verify that the HBA state is Ready, Link Up and that each target
entry state is Session Active
Figure 73 Target Settings tab
.
(Figure 72).
(Figure 73).
MPX200 Multifunction Router User Guide 101