Fujitsu ServerView Virtual-IO Manager V3.1 User Manual page 214

5 Virtual-IO Manager user interface
IPv4 address
Static client IP address to be used for this port. The port will use this IP
address for the entire iSCSI session. You can enter an IP address in this
field if Address Origin: static is selected.
Subnet Mask
IP subnet mask. This should be the IP subnet mask of the network used
to connect this port (in the case of an iSCSI boot). You can enter a sub-
net mask in this field if Address Origin: static is selected.
Gateway Address
IP address of the network gateway. You can enter the gateway address
in this field if Address Origin: static is selected. This is necessary if
the iSCSI target is in a subnetwork other than the subnetwork of the
selected iSCSI boot port.
If iSCSI initiator and target are in the same network segment, no gate-
way is needed. The gateway address should be set to the value 0.0.0.0.
Target Parameters
Address Origin
DHCP
The system tries (in the case of an iSCSI boot) to obtain the name
of the iSCSI target, the IP address of the iSCSI target, the IP port
number, and the SCSI LUN ID from a DHCP server in the network.
static
Static name for the iSCSI target, a static IP address for the iSCSI
target, a static IP port number, and a static SCSI LUN ID.
Target Name
IQN name of the iSCSI target. You can enter a name in this field if
Address Origin: static is selected.
214 ServerView Virtual-IO Manager