Set System Contact - Enterasys N Standalone (NSA) Series Configuration Manual

2.2.3.28

set system contact

Use this command to identify a contact person for the system.
set system contact [string]
Syntax Description
string
Command Defaults
If string is not specified, the contact name will be cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system contact string:
Matrix(rw)->set system contact "Joe Smith"
(Optional) Specifies a text string that contains the name
of the person to contact for system administration.
NOTE: A contact string containing a space in
the text must be enclosed in quotes as shown in
the example below.
Matrix NSA Series Configuration Guide
General Configuration Command Set
Setting Basic Device Properties
2-77