Set System Location - Enterasys N Standalone (NSA) Series Configuration Manual

General Configuration Command Set
Setting Basic Device Properties
2.2.3.27

set system location

Use this command to identify the location of the system.
set system location [string]
Syntax Description
string
Command Defaults
If string is not specified, the location name will be cleared.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system location string:
Matrix(rw)->set system location "Bldg N32-04 Closet 9"
2-76 Matrix NSA Series Configuration Guide
(Optional) Specifies a text string that indicates where
the system is located.
NOTE: A location string containing a space in
the text must be enclosed in quotes as shown
in the example below.