Enterasys N Standalone (NSA) Series Configuration Manual page 77

Table 2-6 show system Output Details
Output
System contact
System location
System name
PS1 and
PS2-Status
Fan Status
Temp-Alarm
Uptime d,h:m:s
Logout
PS1 and
PS2-Type
What It Displays...
Contact person for the system. Default of a blank string can
be changed with the set system contact command
(Section 2.2.3.28).
Where the system is located. Default of a blank string can
be changed with the set system location command
(Section 2.2.3.27).
Name identifying the system. Default of a blank string can
be changed with the set system name command
(Section 2.2.3.26).
Operational status for power supply 1 and, if installed,
power supply 2.
Operational status of the fan tray.
Whether or not the system temperature alarm is off (within
normal temperature range) or on.
System uptime.
Time an idle console or Telnet CLI session will remain
connected before timing out. Default of 15 minutes can be
changed with the set logout command
Model number of power supply 1 and, if installed, power
supply 2.
Matrix NSA Series Configuration Guide
General Configuration Command Set
Setting Basic Device Properties
(Section 2.2.3.32).
2-51