Set Summertime Recurring - Enterasys N Standalone (NSA) Series Configuration Manual

2.2.3.17

set summertime recurring

Use this command to configure recurring daylight savings time settings. These settings will start
and stop daylight savings time at the specified day of the month and hour each year and will not
have to be reset annually.
set summertime recurring start_week start_day start_month start_hr_min
end_week end_day end_month end_hr_min [offset_minutes]
Syntax Description
start_week
start_day
start_hr_min
end_week
end_day
end_hr_min
offset_minutes
Command Defaults
If an offset is not specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Specifies the week of the month to restart daylight
savings time. Valid values are: first, second, third,
fourth, and last.
Specifies the day of the week to restart daylight savings
time.
Specifies the time of day to restart daylight savings time.
Format is hh:mm.
Specifies the week of the month to end daylight savings
time.
Specifies the day of the week to end daylight savings
time.
Specifies the time of day to end daylight savings time.
Format is hh:mm.
(Optional) Specifies the amount of time in minutes to
offset daylight savings time from the non-daylight
savings time system setting. Valid values are 1 - 1440.
Matrix NSA Series Configuration Guide
General Configuration Command Set
Setting Basic Device Properties
2-65