Set Vlan Dynamicegress - Enterasys N Standalone (NSA) Series Configuration Manual

7.3.4.5

set vlan dynamicegress

Use this command to set the administrative status of one or more VLANs' dynamic egress
capability. If VLAN dynamic egress is enabled, the device will add the port receiving a tagged
frame to the VLAN egress list of the port according to the frame VLAN ID.
set vlan dynamicegress vlan-list {enable | disable}
Syntax Description
vlan-list
enable | disable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable the dynamic egress function on VLAN 7:
Matrix(rw)->set vlan dynamicegress 7 enable
Specifies the number of the VLAN(s) where dynamic
egress will be enabled or disabled.
Enables or disables dynamic egress.
Matrix NSA Series Configuration Guide
VLAN Configuration Command Set
Configuring the VLAN Egress List
7-31