Table of Contents
Advertisement
This example shows how to set the WebView TCP port to 100.
Matrix(rw)->set webview port 100
2.1.5
Process Overview: CLI Startup and General Configuration
Use the following steps as a guide to the startup and general configuration process:
1. Starting and navigating the Command Line Interface (CLI)
2. Configuring the Line Editor
3. Setting user accounts and passwords
4. Enabling or disabling of the management authentication notification MIB
5. Setting basic device properties
6. Activating licensed features
7. Downloading a new firmware image
8. Reviewing and selecting the boot firmware image
9. Starting and configuring Telnet
10.Managing image and configuration files
11.Enabling or disabling the MTU discovery protocol
12.Pausing, clearing and closing the CLI
13.Resetting the device
14.Gathering Technical Support Information
15.Preparing the device for router mode
(Section
2.1.7)
(Section
(Section
2.2.3)
(Section
2.2.4)
(Section
(Section
(Section
(Section
2.2.11)
(Section
Startup and General Configuration Summary
Process Overview: CLI Startup and General Configuration
(Section
2.2.1)
2.2.5)
(Section
2.2.6)
2.2.7)
(Section
2.2.8)
(Section
2.2.9)
2.2.10)
(Section
2.2.12)
2.3)
Matrix NSA Series Configuration Guide
2.1.6)
(Section
2.2.2)
2-11
Advertisement
Chapters
Table of Contents
