Enterasys N Standalone (NSA) Series Configuration Manual page 30

Startup and General Configuration Summary
Factory Default Settings
Table 2-1 Default Device Settings for Basic Switch Operation (Continued)
Device Feature
Policy classification
Port auto-negotiation
Port advertised ability
Port broadcast
suppression
Port duplex mode
Port enable/disable
Port priority
Port speed
Port trap
Priority classification
RADIUS client
RADIUS last resort
action
RADIUS retries
RADIUS timeout
Rate limiting
SNMP
SNTP
Spanning Tree
Spanning Tree edge
port administrative
status
2-4 Matrix NSA Series Configuration Guide
Default Setting
Classification rules are automatically enabled when created.
Enabled on all ports.
Maximum ability advertised on all ports.
Disabled (no broadcast limit).
Set to half duplex, except for 100BASE-FX and 1000BASE-X,
which is set to full duplex.
Enabled.
Set to 1.
Set to 10 Mbps, except for 1000BASE-X, which is set to 1000 Mbps,
and 100BASE-FX, which is set to 100 Mbps.
All ports are enabled to send link traps.
Classification rules are automatically enabled when created.
Disabled.
When the client is enabled, set to Challenge.
When the client is enabled, set to 3.
When the client is enabled, set to 20 seconds.
Disabled (globally and on all ports).
Enabled.
Disabled.
Globally enabled and enabled on all ports.
Enabled.