Set Width - Enterasys N Standalone (NSA) Series Configuration Manual

General Configuration Command Set
Setting Basic Device Properties
2.2.3.29

set width

Use this command to set the number of columns for the terminal connected to the device's console
port. The length of the CLI is set using the set length command as described in
set width screenwidth
Syntax Description
screenwidth
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the terminal columns to 50:
Matrix(rw)->set width 50
2-78 Matrix NSA Series Configuration Guide
Sets the number of terminal columns. Valid values are 50 to
150.
Section 2.2.3.30.