Cli "Command Defaults" Descriptions; Cli Command Modes; Sample Cli Default Description - Enterasys N Standalone (NSA) Series Configuration Manual

Table 2-2 Default Device Settings for Router Mode Operation (Continued)
Device Feature
SNMP
Split horizon
Stub area (OSPF)
Telnet
Telnet port (IP)
Timers (OSPF)
Transmit delay (OSPF)
VRRP
2.1.2

CLI "Command Defaults" Descriptions

Each command description in this guide includes a section entitled "Command Defaults" which
contains different information than the factory default settings on the device as described in
Table 2-1 and Table
command without typing optional parameters (indicated by square brackets [ ]). For commands
without optional parameters, the defaults section lists "None". For commands with optional
parameters, this section describes how the CLI responds if the user opts to enter only the keywords
of the command syntax.
Figure 2-1 Sample CLI Default Description
show port status [port-string]
Command Defaults
If port-string is not specified, status information for all ports will be displayed.
2.1.3

CLI Command Modes

Each command description in this guide includes a section entitled "Command Mode" which states
whether the command is executable in Admin (Super User), Read-Write or Read-Only mode. Users
with Read-Only access will only be permitted to view Read-Only (show) commands. Users with
Read-Write access will be able to modify all modifiable parameters in set and show commands, as
Default Setting
Enabled.
Enabled for RIP packets without poison reverse.
None configured.
Enabled.
Set to port number 23.
SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Set to 1 second.
Disabled.
2-2. The command defaults section defines CLI behavior if the user enters a
Figure 2-1 provides an example.
Startup and General Configuration Summary
CLI "Command Defaults" Descriptions
Matrix NSA Series Configuration Guide 2-9