Set System Utilization Threshold - Enterasys N Standalone (NSA) Series Configuration Manual

2.2.3.10

set system utilization threshold

Use this command to set the threshold for sending CPU utilization notification messages.
value range is [1..1000] and represents the % of system utilization to use as the trap
threshold.
set system utilization threshold threshold
Syntax Description
threshold
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the system utilization threshold to 100%:
Matrix(rw)->set system utilization threshold 1000
Specifies a threshold value (in 1/10 of a percent).Valid
range is 1 - 1000. A value of 0 will disable utilization
notification messages.
Matrix NSA Series Configuration Guide
General Configuration Command Set
Setting Basic Device Properties
The
2-57