Canon OPTURA 100 MC NTSC Instruction Manual page 96

.'*2
tu
When you play back a tape that was recorded in 12-bit mode, you can set the
audio output to play: stereo 1 (the original sound), stereo 2 (any new sound,
dubbed to the tape after recording), or mix the balance between the two.
• Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/do
not need to select the audio mix. The same is tree for the 12-bit stereo 1 mode,
unless new sound has been added post-recording.
+
Choose the output.
° Press AUDIO MONITOR on the wh'eless controllel:
• Starting with the last selected setting, 4 settings appear as you push the
button:
- STEREOI for just stereo 1.
- STEREO2 for just stereo 2.
- MIX/FIXED for an equal mix of stereo 1 and 2.
- MIX/VARI. (mix variable) for when you want to mix the balance between
stereo 1 and 2.
, To simply choose STEREO1, STEREO2 or MIX/FIXED, make sure your
choice appears on the display.
• If you choose MI[X!VARI., you can go on to mix the balance.
• Use the ST-I/ST-2 keys to mix the balance. A bar showing the mix appears
on the screen for 4 seconds.
[] Note:
• When you have chosen the output, STEREOI, STEREO2,
MIX/FIXED or
MIX/VARL is shown in the top left of the display for a few seconds. If you turn
the power off the output is set to STEREOI.
96