Canon OPTURA 100 MC NTSC Instruction Manual page 119

4. Select t he
desired setting.
• Your currently recording image is combined with the pre-recorded still
image.
5. Select MIX LEVEL.
6. Adjust the mix level.
" Tnrning the selector dial upwards adjusts to the right and turning
downwards adjusts to the left.
7. Close tile menu.
, CARD MIX flashes in the display.
[ On/Off ]
8. Press the card MIX button.
, CARD MIX stops flashing.
• Your currently recording hnage is combined with the pre-recorded still
image.
• Each time you press the card MIX button, your selection is activated
(display lights continuously) or deactivated (display flashes).
For movies ]
1. Press the start/stop button to start and stop recording.
, The combined images are recorded onto the cassette.
For stills ]
1. Press the PHOTO button halfway down and hold it.
• O flashes white in the display as the camcorder adjusts the focus and it is
displayed continuously its it green mark when the camcorder is ready to take
the image.
2. Press the PHOTO button fully down to record the image to the
cassette, c
, O disappears from the display. _. =
, The combined images are recorded onto the cassette for approximately 6 ua
seconds (8 seconds in the r--ISPor I=-ILPrecording mode).
iN
[] Notes: 3
0
• If yon change the position of the POWER switch, select your still image for ,_
Citrd Mix again.
, When setting Card Mix, you must carry out steps 1 to 4. 7,
119