The Tape - Canon OPTURA 100 MC NTSC Instruction Manual

This allows you to move quickly through still pictures recorded anywhere on a
tape (photo search) or between different days o1 areas of recording (date search)
on a tape.
+
1. Press the SEARCH SELECT button to choose between
photo/date
search.
, PHOTO SEARCH or DATE SEARCH is shown in the display for 4
seconds.
2. Press the 1,9,_ and _ buttons to move backwards or forwards
through
the still
pictures
or between different
days of recording.
• Press once to move to the start of the previous/next still picture or day on
the tape.
, You can press more than once to move to the corresponding still picture or
day (up to a maximum of 10 times), e.g. press the _Dq button 5 times to
move folwvard 5 still pictures or days.
, PHOTO SEARCH/DATE SEARCH appears in the middle of the display
alongside the _1 or _.t mark and number to search through. You can
change direction easily by pressing the button for the opposite direction.
[] Notes:
" Press [] (stop) to stop mid-search.
, If you begin a search very close to the start of a recorded still picture during
photo search, the camcorder may skip straight past it.
, When you have set the area for the World Clock, date search also looks for the
change in date based on the adjusted time.
, A date/area cannot be identified if the total recording time on that day/area was
less than 1 minute.
• Date search playback may start just before or after the beginning of the located
section.
• If the data code is not displayed correctly you will not be able to operate the
date search correctly.
3Jc
_=
e:
83