Canon OPTURA 100 MC NTSC Instruction Manual page 17

iiiiii! !i
Only use videocassettes marked with the M,,_, logo.*
1. Make sure that you have attached a power source.
2. Slide the OPEN / EJECT _ switch (on the bottom of the
camcorder) to release the cassette compartment cover.
• Pull the cover fully open (while holding the button) and wait a couple of
seconds for the cassette compartment to open automatically.
° The confirmation beep sounds when the cassette cover fully opens.
3. Load or unload tile cassette.
• Insert the cassette gently with the window facing the grip belt, and the
REC/SAVE tab outwards.
• Remove the cassette by pulling it straight out.
4. Press the _ mark on the compartment until it clicks, and wait
for it to close.
5. Click the cover back into place.
, M,,_v is a trade mark.
[] Notes:
, Do not interfere with tile cassette compartment while it is opening or closing
automatically, and do not attempt to close the cover until the cassette
compartment has fnlly retracted.
, After loading a cassette, use record search ((_136) to find the point where you
want to start recording.
, Be careful not to get your fingers caught in the cassette compamnent cover
, Do not leave the cassette in the camcorder after use -- return it to its case and
store it in a cool, clean, dU place.
, When you turn the camcorder's power on, _ flashes in the display until you
load a cassette.
, With some types of tapes, the remaining tape display may not give an accurate
reading ( _ 144).
17