Canon OPTURA 100 MC NTSC Instruction Manual page 52

O'1
e-
• If the subject is unsuitable for autofocus (_1136), the camcorder n-lay not
be able to focus, and O may continue to flash white in the display. Continue
to hold the PHOTO button halfway down, then adjust the focus manually
with the selector dial.
• If you are using manual focus ( {2_77), the O mark starts its a continuous
green mark. Focus with the selector dial.
2. Press tile PHOTO button ftdly down to take tile still picture.
. The camcorder takes the image hnmediately, and then records the "photo" to
the tape for approximately 6 seconds",:. During this time the camcorder also
records the sound, and the display show-s the still picture.
. A counter display appears, and counts up its the camcorder records the
picture. O disappears from the display.
• The camcorder returns to record pause mode.
[] Notes:
. The camcorder automatically returns to record pause mode after recording it
still image for approximately 6 seconds".:. If you turn the POWER switch to
OFF during that time, the camcorder will respond only after recording is
complete.
• The wireless controller's PHOTO button hits no half-way setting. Press the
button fully and the camcorder immediately takes the "photo".
• Only take "photos" where it is bright enough to see the hnage in the display.
*8 seconds in I---ISP or F'-ILPrecording mode.
52