Canon OPTURA 100 MC NTSC Instruction Manual page 84

_3_ kL
.-="8
e-
[Z
Use the wireless controller to mark a point on a tape that you want to return to
following playback.
+ +
1. Press the ZERO SET MEMORY button on the wireless controller
during playback at a point you want to return to later.
• The thne code is replaced by a tape counter that is set to zero with the []
indication.
. Press the ZERO SET MEMORY button once morn to cancel the zero set
memo U.
2. When you have finished playback, fast lbrward or rewind the tape.
Tile tape stops automatically when it reaches tile zero set position.
• RTN_ or 44RTN appears in the display.
• The tape counter with [] indication disappears from the display and the time
code reappears.
[] Notes:
• The zero set memol-y may not function correctly where there is a break between
recordings on the tape.
° You can also use zero set memo U to mark a position on a tape in TAPE
CAMERA mode. When you then play back the tape, pressing rewind will take
you back to the pre-marked position.
° If you remove the tape while the zero set memo U is set, the memo W is
canceled and the tape counter revel-ts to time code.
, The camcorder remembers your setting even if you turn it off and back on again
or move the program selector.
84