Set up Mode
The Set up function consists of two
different screens that allow you to
change and update information in the
system. To display the Set up screens,
use the voice control system and say
"Set up," or press the INFO button and
select Set up, and then select an item,
say or select More in the upper right
corner of the screen.
On any of the Set up screens, you can
use the voice control system to select
any item on the screen.
• If some items appear to be grayed
out, and cannot be selected, it is
because you did not select OK on the
initial Disclaimer screen. See System
Start- up on page 16.
• For information about the available
voice commands, see Voice
Command Index on page 118.
Set up Screen (first)
From any screen, say "Set up" or press
the INFO button and select Set up, and
the following screen appears:
The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say "Brightness up"
or "Brightness down." You can also
select the Bright. bar and move the
cursor by pushing the joystick left or
right, or by touching the arrowhead in
If you are having trouble viewing the
screen, try increasing the brightness.
You can have a separate daytime and
nighttime setting for brightness. Adjust
each setting when the Display is in
either Day or Night mode.
The navi voice volume is adjustable in
10 steps, and also can be turned off. To
adjust the volume, use the voice control
system and say "Volume up" or "Volume
down." You can also select the Volume
bar and move the cursor by pushing the
joystick left or right, or by touching the
arrowheads in the bar. After adjusting
the volume, you will hear beeps at the
new volume level. You can also select
If you turn the volume off, you will not
hear route guidance or voice command