Table of Contents
Advertisement
Setup Mode
The Setup function consists of two
different screens, that allow you to
change and update information in the
system. To display the Setup screens,
use the voice control system and say
"Setup," or press the SET UP button,
and then select an item, say or select
More in the upper right corner of the
screen.
On any of the Setup screens, you can
use the voice control system to select
any item on the screen.
NOTE:
• If some items appear to be grayed
out, and cannot be selected, it is
because you did not select OK on the
initial Disclaimer screen. See System
Start-up on page 17.
• For information on the available
voice commands, see Voice
Command Index on page 124.
Setup Screen (first)
From any screen, say "Setup" or press
the SET UP button and the following
screen appears:
Brightness
The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say "Brightness up"
or "Brightness down." You can also
select the Bright. bar and move the
cursor by pushing the joystick left or
right, or by touching the arrowhead in
the bar.
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.
System Set-up
NOTE:
You can have a separate daytime and
nighttime setting for brightness. Adjust
each setting when the Display is in
either daytime or nighttime mode.
Volume
The volume of the tones and voice is
adjusted in 11 steps. To adjust the
volume, use the voice control system
and say "Volume up" or "Volume
down." You can also select the Volume
bar and move the cursor by pushing the
joystick left or right, or by touching the
arrowheads in the bar. After adjusting
the volume, you will hear beeps at the
new volume level. You can also select
volume off.
NOTE:
If you turn the volume off, you will not
hear route guidance or voice command
confirmations.
Navigation System
73
Advertisement
Table of Contents
